Case2.0: Add packing guide

docs/case2.0/packing.md

@@ -0,0 +1,51 @@
+---
+title: Packing Guide
+---
+
+Packing the cases shouldn't be too complicated, but a few details need special attention.
+
+## Case x.1
+Compartments (from left to right):
+
+- **Power cables**: Schuko extension cords, power strips, schuko to TRUE1, schuko to C13, cable mats
+- **Accessories (back tower)**: Intercom crate, ethernet crate, audio and DI crate
+- **Accessories (front tower)**: Batteries and lucky cat crate, tape crate, embedder and converters crate
+- **Accessories (sorting box)**: Small adapters box
+- **Camera**: Tally crate, Mixer laptop crate, Camera crate
+- **XLR Cables**: Multiple XLR cables and Headphones (in a bag)
+- **Video Cables**: Multiple SDI and HDMI cables
+
+![](img/voc-case2_0-case_b-comp.jpeg) <!-- TODO: get a better image -->
+
+### Fitting the Tripod
+!!! info ""
+    Put all dampers (pan, tilt, counterweight) on zero and loosen the breaks before storing the tripod in the bag.
+    This way, everything can move to fit snugly.
+
+![](img/voc-case2_0-tripod-comp.jpg){ align="right", width="250" }
+The carrying bag of the new Sachter Ace M Mk II tripods got bigger than the old generation which means that the space in the case is quite tight.
+
+To make everything fit, place the tripod with the head to the right and carrying handle to the back (so it gets past the wooden compartment board).
+Otherwise the case lid may not close without forcing it.
+
+Please also take care of the remote control and place it on top and away from the front edge of the case so that it can't be jammed when closing the lid.
+There should be enough space between the legs of the tripod.
+
+### Fitting the Power Cables
+It's recommended to put the rubber cable mats in the compartment first, then the long cables and the power strips on top.
+
+
+## Case x.2
+Compartments (from left to right):
+
+- **FOH module** (bottom side to the left)
+- **Supplies**: c3lingo (currently only a placeholder) crate, office crate, minion crate, microphones crate
+- **ethernet compartment**: Multiple long ethernet cables
+- **Lectern module** (bottom side to the left)
+- **Encoder module** (bottom side to the left)
+
+<!-- TODO: get a picture showing the modules inside the case -->
+
+!!! info ""
+    Place all modules with the bottom to the left.
+    This way everything is "upright" when the case is loaded on the pallet.